Travertine flooring – Travertine is a form of limestone that is created inside the hot springs. The water vapor that escapes leaves behind several pustules or holes in the stone. These holes must be filled, either the manufacturer or during installation, to ensure the integrity of the stone. Since the filling into the holes you are made of either epoxy or grout, it can sometimes get out, leaving your floor with a hole in it. To repair your travertine floor, you need more than the original slurry, for fallen floors, or a repair kit for honed travertine stones, pre-loaded.
Repair travertine flooring, Clean the floor and travertine around the hole with a stone cleaner. Wash anything that has accumulated inside the hole, as this may interfere with the adhesion of new landfill. Wipe dry with an absorbent cloth stone. Mix a small amount of grout or epoxy paste in the kit travertine. Both should resemble the consistency of peanut butter when finished. Add water to the dry mixture slowly, stirring all the time so it does not add more.
Travertine flooring, Collect some new fill with a stick paint layer and into the hole. If the hole is deep or passes through the stone, you can solve. If this happens, the layer of extra padding. Turn the paint stick on its side and scrape the top of the stone to remove excess. Clean the surface around the hole repaired with a damp sponge to remove excess filling. Be careful not to disturb the hole for at least 24 hours.#ThanksForReading SBC